Figure 13. Drive Bay Locations

You can install these drives in a front drive bay or a rear drive bay:

∙A 3.5-inch floppy drive comes attached to the underside of the front drive bay. The CD-ROM is mounted in the bottom slot of the bay, and the Zip drive is located in the middle slot directly above the CD-ROM drive. The bay can hold an additional drive in the upper slot, positioned so that it is accessible from outside the computer. Install a floppy or a tape-backup drive there.

∙The rear drive bay contains an IDE hard drive and space for two additional drives, positioned so that they are inaccessible from outside the computer. Install only hard drives there.

The system board has three connectors to support the additional drives you may install:

∙A built-in floppy controller that supports up to two floppy drives, one of which comes installed on your system.

∙Two IDE connectors, each of which supports up to two IDE devices. The Primary connector supports your hard

26 Advantage! 9000 Series User’s Manual