
Figure 12. Installing an
b.Insert the board until its edge connector is aligned with an
c.Using evenly distributed pressure, push the board straight in until it is fully inserted in the slot.
d.Reinstall the bracket screw you removed in step 5.
7.Attach any cables needed to connect the
∙If the board requires a cable to be attached to a device on the other side of the chassis, a slot on the riser card/ fan support provides a way to route cables without interfering with the system cover.
∙If the board is a
8.Replace the bottom panel. Set the system upright and replace the system cover. Reconnect peripheral devices, plug in the power cord, and boot the system.
24 Advantage! 9000 Series User’s Manual