Iomega 9000 Series manual 43

2.To access the SIMM slots, you must first remove the rear drive bay:

a.Remove the rear drive bay panel (see “Removing the Rear Drive Bay Panel” on page 32).

b.Remove any drives that may be mounted in the rear drive bay panel by pressing in on the tabs on the drive rails and pulling the drives out of the drive bay.

c.Slide the drive cage out of the tabs that secure it to the chassis, and remove from the chassis.

3.Locate the SIMM slots on the system board. Refer to the illustration in the back of this manual.

4.If necessary, remove any add-in boards that block easy access to the SIMM slots.

5.If you need to remove a SIMM, carefully pull the retaining clips from the edges of the SIMM (Figure 19). At the same time, push the SIMM slightly forward from the back.

Remove the SIMM carefully to avoid damage.

36 Advantage! 9000 Series User’s Manual