CONNECTIONS
Connecting the antennas (RX-V750)
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.
Indoor FM antenna
(included) AM loop antenna (included)
TUNER
75Ω UNBAL.
AM
FMGND ANT ANT
Ground (GND terminal)
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
■Connecting the AM loop antenna
1Set up the AM loop antenna, then connect it to the terminals on this unit.
2Press and hold the tab to insert the AM loop antenna
lead wires into the AM ANT and GND terminals.
3Orient the AM loop antenna for the best reception.
Notes
•The AM loop antenna should be placed away from this unit.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.
■FREQUENCY STEP switch
(Asia and General models only)
Because the interstation frequency |
|
|
|
spacing differs in different areas, set | FREQUENCY STEP | ||
| |||
the FREQUENCY STEP switch |
|
| 10KHZ / 100KHZ |
|
| 9KHZ / 50KHZ | |
|
|
| AM FM |
(locating on the rear panel) according |
|
|
|
to the frequency spacing in your area. |
|
|
|
•North, Central and South America: 100 kHz/10 kHz
•Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect this unit’s power cord from the AC wall outlet.
22
