REMOTE CONTROL FEATURES
Notes
•“NG” appears in the display window if programming was unsuccessful. In this case, start over from step 5.
•This remote control can learn approximately 120 functions. However depending on the signals learned, “FULL” may appear in the display before you program 120 functions. In this case, clear unnecessary programmed functions to make room for further learning.
6Repeat steps 4 and 5 to program additional functions.
Changing source names in the display window
You can change the name that appears in the display window on the remote control if you want to use a different name to the one that is set as the factory preset. This is useful when you have set the input selector to control a different component.
1Press an input selector button to select the source component you want to rename.
The selected component name appears in the display
7 Press LEARN again to exit from the learning | window. |
mode. |
|
A | B | PHONO MULTI CH IN |
LEARN
DTV/CBL | VCR 1 | DVR/VCR2 | DVD |
Notes
•Learning may not be possible in the following cases:
–When the batteries in the remote control for this unit or other components are weak.
–When the distance between the two remote controls is too great or too small.
–When the remote control infrared windows are not facing at the appropriate angle.
–When the remote control is exposed to direct sunlight.
–When the function to be programmed is continuous or uncommon.
•“ERROR” appears in the display window if you press more than one button at the same time.
2Press
ballpoint pen or similar | |
object. |
|
3Press u / d to select and enter a character.
Pressing d changes the character as follows:
A to Z, a to z, 0 to 9, space,
+
TV VOL
CH | TV MUTE | CH | |
– | + | ||
SELECT |
PRESETPRESET
TV VOL
– 
4Press j / i to move the cursor to the next position.
+
TV VOL
CH | TV MUTE | CH | |
– | + | ||
SELECT |
PRESET
TV VOL
–
y
If you want to continue setting up names for other components, press TV MUTE/SELECT and repeat steps 1, 3 and 4.
5Press
70
