ION RX-V750, DSP-AX750SE owner manual IMPEDANCE SELECTOR switch

CONNECTIONS

■IMPEDANCE SELECTOR switch

CAUTION

Do not change the setting of the IMPEDANCE SELECTOR switch when the unit power is switched on, as doing so may damage the unit.

If this unit fails to turn on when STANDBY/ON is pressed on either the front panel or remote control, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If this is the case, slide the switch all the way to either position when this unit is in standby mode.

Select the switch position (left or right) according to the impedance of the speakers in your system.

					SET BEFORE POWER ON
					IMPEDANCE SELECTOR
			IMPEDANCE SELECTOR switch
Switch position	Speaker			Impedance level
		If you use one set (A or B), the impedance of each speaker must be
		4 Ω or higher.
	Front
Left		If you use two sets (A and B), the impedance of each speaker must be
		8	Ω or higher.
	Center, Surround, Surround back,	The impedance of each speaker must be 6				Ω or higher.
	Presence
		If you use one set (A or B), the impedance of each speaker must be
		8 Ω or higher.
	Front
Right		If you use two sets (A and B), the impedance of each speaker must be
		16 Ω or higher.
	Center, Surround, Surround back,	The impedance of each speaker must be 8				Ω or higher.
	Presence

24