ZyAIR
Table
STEPS | CORRECTIVE ACTION |
1Make sure you connect your cable or DSL modem or router to this port using the Ethernet cable that came with your cable or DSL modem or router.
2Verify that the attached device is turned on and properly connected to the ZyAIR.
3Verify that the Ethernet cable length does not exceed 100 meters.
23.2 Web Configurator
I cannot access the web configurator.
Table
STEPS | CORRECTIVE ACTION |
1Make sure you are using either Internet Explorer (version 4.0 and later) or Netscape Navigator (version 6.0 and later).
2Make sure you are using the correct WAN or LAN IP address. The default LAN IP address is 192.168.1.1.
3Make sure you entered the correct username and password. The default administrator username is “admin” and the default password is “1234”. The username and password are
If you have forgotten the administrator user name and/or password, you must reset the ZyAIR back to the factory defaults using the reset button. Use a pointed object to press the reset button on the side panel to reset the ZyAIR. All of your custom configuration will be lost.
4Ping the ZyAIR from your computer on the WAN or LAN.
If you cannot ping the ZyAIR, check the IP addresses of the ZyAIR and your computer. Make sure that both IP addresses are in the same subnet.
5Delete the temporary web files and log in again.
In Internet Explorer, click Tools, Internet Options and then click the Delete Files ... button. When a Delete Files window displays, select Delete all offline content and click OK. (Steps may vary depending on the version of your Internet browser.)
In Netscape, click Edit, Preference. Under Advanced category, click Cache. Click Clear Memory Cache and Clear Disk Cache. (Steps may vary depending on the version of your Internet browser.)
6Disable any HTTP proxy settings in your web browser.
Troubleshooting |