Manuals / Jackson / Kitchen Appliance / Dishwasher

Jackson Tempstar TGP technical manual Installation Manual For Export Units, Technical Manual

Models: Tempstar TGP

1 41

Download 41 pages 54.93 Kb

Page 1

DUAL TEMPERATURE, GAS HEATED

DUAL TEMPERATURE, GAS HEATED

DOOR-TYPE DISHMACHINES

TECHNICAL MANUAL

INSTALLATION MANUAL FOR EXPORT UNITS

SERVICE MANUAL FOR DOMESTIC UNITS

FOR JACKSON MODEL:

TEMPSTAR TGP

June 24, 2004

P/N 7610-001-98-99 (Revision C)

An Company

Jackson MSC, Inc.

P.O. BOX 1060

HWY. 25E

BARBOURVILLE, KY. 40906

FAX (606) 523-9196

PHONE (606) 523-9795

www.jacksonmsc.com

Image 1

Jackson Tempstar TGP technical manual Installation Manual For Export Units, June 24 P/N 7610-001-98-99 Revision C

Contents

June 24 P/N 7610-001-98-99 Revision C INSTALLATION MANUAL FOR EXPORT UNITSDUAL TEMPERATURE, GAS HEATED DOOR-TYPE DISHMACHINES TECHNICAL MANUALINSTALLATION TABLE OF CONTENTSSCHEMATICS GENERALSPECIFICATIONS OF THE TEMPSTAR TGP Page GAS CONNECTION OPERATION INSTRUCTIONS OVERVIEW OF OPERATION OVERVIEW OF OPERATION CONTINUED THERMOSTAT ADJUSTMENT PROCEDURE Model TEMPSTAR GP, & TEMPSTAR TGP AUTO-CALIBRATION PROCEDUREAUTO - CALIBRATION ELECTRONICS CONTROL BOARD ECB Testing and Setting the Set Point TemperatureTo test the temperature at the T-in Thermistor TESTING THE THERMISTORSTo test the temperature at the T-Mid Thermistor 1 Green LED is off CONTROL BOARD LED LIGHT INDICATIONS2 Green LED is a illuminated and steady 3 Green LED is illuminated and flashingUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONSymptom Possible CauseUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONMeasure the continuity between terminals # and has an O-ring. Check to ensure that theUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONCAUTION WHEN CHECKING FOR GAS Using an approved leak detector, determineUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONSymptom Possible CauseUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONPOLARITY WILL DAMAGE THE CIRCUIT BOARDSUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONCheck height of probe above burner should be seen at this spade. If none, replace DSIUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONRemove burner manifold and check correct DIMENSIONS TABLE DIMENSIONS CORNER INSTALLATION TABLE DIMENSIONSTABLE DIMENSIONS CONNECTION TO DISHMACHINE TABLE DIMENSIONS STRAIGHT04-NOT MAIN ASSEMBLYSHOWN 07-NOT SHOWNCONTROL BOX ASSEMBLY - FRONT VIEW CONTROL BOX ASSEMBLY - TOP VIEW HOOD ASSEMBLY CANTILEVER ARM ASSEMBLY TUB ASSEMBLY BACK OF TUB, & DRAIN ASSEMBLY LOWER ASSEMBLY RIGHT SIDE INCOMING PLUMBING ASSEMBLY INCOMING PLUMBING PARTS LISTS GAS PACK ASSEMBLY UPPER WASH, & RINSE ARM ASSEMBLY LOWER WASH, & RINSE ARM ASSEMBLY STEAM COIL ASSEMBLY STEAM COIL ASSEMBLY PARTS LISTS THIS ASSEMBLY RINSE TANK ASSEMBLYNOTETHESE UNIONS ARE NOT INCLUDED WITHGREEN ELECTRONIC CONTROL DRAWER COMPONENTSMETRIC CONVERSIONS 208/240 VOLT - 50 HERTZ - 1 PHASE ELECTRICAL DIAGRAMTempstar TGP