Manuals / Jackson / Kitchen Appliance / Dishwasher

Jackson Tempstar TGP technical manual Tub Assembly

Models: Tempstar TGP

1 41

Download 41 pages 54.93 Kb

Page 28

TUB ASSEMBLY

TUB ASSEMBLY

	01		02		03		04		05		06		07		08		09		10		11		12

																								13


	ITEM	QTY	DESCRIPTION	MFG NO.

	01	1	Bracket, Reciculating Pump	5700-002-14-85
	02	2	Lock Washer, 5/16" s/s Split Ring	5311-275-01-00
	02	2	Bolt, Hex Head 5/16"- 18 X 5/8"	5305-275-09-00
	03	1	Pump, Recirculating 220v Assembly	5700-002-17-77
	04	1	Bracket, Thermostat	5700-011-73-77
	05	1	Thermostat, Wash Temperature Over Limit 78 Deg	5930-121-67-72
	06	3	Clamp, 5/8" Nylon	4730-011-39-01
	07	2	Elbow, 90Deg 1/2" Street Brass	4730-206-08-00
	08	1	Thermometer, Wash 96" Lead	6685-111-68-49
	09	1	Probe, High Water	6680-200-02-68
	10	1	Hose Assembly, Wash Pump Discharge 1 1/4" ID	5700-002-18-85
	11	2	Clamp, Reg. Range 1 5/16"- 2 1/4"	4730-719-01-37
	12	1	Tub Weldment	5700-002-18-77
	13	1	Wash Pump & Motor Assembly, 240v/50hz/1ph	6105-002-19-87

26

Image 28

Jackson Tempstar TGP technical manual Tub Assembly

Contents

INSTALLATION MANUAL FOR EXPORT UNITS June 24 P/N 7610-001-98-99 Revision CDUAL TEMPERATURE, GAS HEATED DOOR-TYPE DISHMACHINES TECHNICAL MANUALTABLE OF CONTENTS INSTALLATIONSCHEMATICS GENERALSPECIFICATIONS OF THE TEMPSTAR TGP Page GAS CONNECTION OPERATION INSTRUCTIONS OVERVIEW OF OPERATION OVERVIEW OF OPERATION CONTINUED THERMOSTAT ADJUSTMENT PROCEDURE Model TEMPSTAR GP, & TEMPSTAR TGP AUTO-CALIBRATION PROCEDUREAUTO - CALIBRATION Testing and Setting the Set Point Temperature ELECTRONICS CONTROL BOARD ECBTo test the temperature at the T-in Thermistor TESTING THE THERMISTORSTo test the temperature at the T-Mid Thermistor CONTROL BOARD LED LIGHT INDICATIONS 1 Green LED is off2 Green LED is a illuminated and steady 3 Green LED is illuminated and flashingTROUBLESHOOTING SECTION USE EXTREME CAUTION WHEN TESTING THE MACHINESymptom Possible CauseTROUBLESHOOTING SECTION USE EXTREME CAUTION WHEN TESTING THE MACHINEMeasure the continuity between terminals # and has an O-ring. Check to ensure that theTROUBLESHOOTING SECTION USE EXTREME CAUTION WHEN TESTING THE MACHINECAUTION WHEN CHECKING FOR GAS Using an approved leak detector, determineTROUBLESHOOTING SECTION USE EXTREME CAUTION WHEN TESTING THE MACHINESymptom Possible CauseTROUBLESHOOTING SECTION USE EXTREME CAUTION WHEN TESTING THE MACHINEPOLARITY WILL DAMAGE THE CIRCUIT BOARDSTROUBLESHOOTING SECTION USE EXTREME CAUTION WHEN TESTING THE MACHINECheck height of probe above burner should be seen at this spade. If none, replace DSIUSE EXTREME CAUTION WHEN TESTING THE MACHINE TROUBLESHOOTING SECTIONRemove burner manifold and check correct DIMENSIONS TABLE DIMENSIONS TABLE DIMENSIONS CORNER INSTALLATIONTABLE DIMENSIONS CONNECTION TO DISHMACHINE TABLE DIMENSIONS STRAIGHTMAIN ASSEMBLY 04-NOTSHOWN 07-NOT SHOWNCONTROL BOX ASSEMBLY - FRONT VIEW CONTROL BOX ASSEMBLY - TOP VIEW HOOD ASSEMBLY CANTILEVER ARM ASSEMBLY TUB ASSEMBLY BACK OF TUB, & DRAIN ASSEMBLY LOWER ASSEMBLY RIGHT SIDE INCOMING PLUMBING ASSEMBLY INCOMING PLUMBING PARTS LISTS GAS PACK ASSEMBLY UPPER WASH, & RINSE ARM ASSEMBLY LOWER WASH, & RINSE ARM ASSEMBLY STEAM COIL ASSEMBLY STEAM COIL ASSEMBLY PARTS LISTS RINSE TANK ASSEMBLY THIS ASSEMBLYNOTETHESE UNIONS ARE NOT INCLUDED WITHELECTRONIC CONTROL DRAWER COMPONENTS GREENMETRIC CONVERSIONS 208/240 VOLT - 50 HERTZ - 1 PHASE ELECTRICAL DIAGRAMTempstar TGP