CARE & CLEANING
BEFORE YOU
CAUTION
¥Be sure appliance is off and all parts are cool before handling or cleaning. This is to avoid damage and possible burns.
CONTROL KNOBS
¥ The control knobs may be removed for easier cleaning.
¥ Before removing the knobs for cleaning, make sure they are in the vertical position.
¥Wash the knobs in soap and water but do not soak.
¥Dry and replace the knobs.
RACK
¥Clean the rack with soap and water.
¥After cleaning, rinse the rack with clean water and dry with a clean cloth.
STAINLESS STEEL
¥Do not use a steel wool pad; it will scratch the surface.
¥Clean with hot soapy water. Rinse and dry.
¥If food soil remains, try a general kitchen cleaner, such as Fantastik¨, Simple Green¨ or Formula 409¨*.
¥For hard to clean soil use a standard stainless steel cleaner such as
several hours with wet towels. Apply cleaner with a damp sponge, rinse thor- oughly and dry. Always scrub lightly in the direction of the grain. After cleaning, use a stainless steel polish such as Stain- less Steel Magic¨**.
WARMING DRAWER PAN
Most cleaning can be done to the pan with the pan in place in the drawer. However, the pan may be removed if further cleaning is needed.
TO REMOVE THE PAN:
¥Open the drawer fully.
¥Using the finger grasp holds on the side of the drawer, lift the pan up and out.
¥Use soap and warm water to thoroughly clean. Rinse and dry.
CALL FOR
SERVICE
Warming drawer will not work.
¥A fuse in your home may be blown or the circuit breaker tripped. Replace the fuse or reset the circuit breaker.
¥Check to see if the Warming Drawer is plugged in.
¥Controls improperly set. See the Using the warming drawer section, pgs.
Drawer does not slide smoothly or drags.
•Ball bearings may be out of alignment. Fully extend the drawer and push it all the way in. See the Care and Cleaning section.
¥Drawer
Excessive condensation.
¥There may be liquid in the warming drawer pan. Remove liquid.
¥Cover food with lid or aluminum foil.
¥Temperature setting is too high. Reduce the temperature setting.
¥Incorrect Moisture Selector setting. Set the Moisture Selector to the open vent setting to allow venting.
No heat in the PROOF setting.
¥Room temperature may prevent the ther- mostat from tripping on. Turn the knob to LOW then back to PROOF.
Food dries out
¥Moisture is escaping. Cover food with lid or aluminum foil.
*Brand names for cleaning products are registered trademarks of the respective manufacturers. ** To order direct, call
6
