Jenn-Air JDB-5 warranty Adjustable Racks select models, Removing the Upper Middle Racks, Tab Lock

LOADING

Adjustable Racks (select models)

The Adjustable Upper Rack (select models) and Adjustable Middle Rack can be raised or lowered to accommodate taller plates, platters, pans, etc. in the upper, middle or lower racks. Full size dinner plates can be loaded in the upper rack if it is in the lower position. Always unload racks before adjusting.

To lower the rack:

Adjusters

1. Pull the rack fully out.

2. Place thumbs on each lever on the adjuster while holding rack with hands.

3. Press down on the levers with

thumbs and push rack down. The rack will come to a stop when it is in position.

To raise the rack:

1.Pull the rack fully out.

2.Place hands on both sides and lift up until rack comes to a stop and latches in place.

Notes

•The dishwasher will not

operate correctly if the rack wash arm connection is not aligned

with one of the water inlet holes on back wall of the dishwasher.

Removing the Upper

and Middle Racks

The racks can be removed when tall or oversized items need to be loaded into the middle or lower rack. Unload the rack before removing it from the dishwasher.

To remove rack with push tab rack stops (select models):

1.Roll the rack 1⁄3 to 1⁄2 of the way out.

2.To remove each plastic push tab rack stop from the end of each track, push inward (toward the rack) on the ridged area of the rack stop. The rack stop will snap open and can be easily removed by pulling straight

out. Take care to

support the track

while removing rack stops.

3. Roll the rack all
the way out of
the track and
remove from the	Push Tab
dishwasher.
	Rack Stop
To replace:

•Reverse the above procedure to replace the rack into the dishwasher.

To remove rack with tab-lock rack stops (select models)

1.Roll the rack 1/3 to 1/2 of the way out.

2.Locate the rack stops at the end of each track. Squeeze the tab in the middle of the rack stop and pull the rack stop straight out. Take care to support the rack while removing the rack stops.

•The left and right side adjusters on the racks must both be fully in the upward or downward position for proper connection.

3.Roll the rack all the way out of the track and remove from the dishwasher.

To replace:

Tab Lock

1. Replace the	Tab Lock
dishwasher rack by	Rack Stop

guiding the wheels into the tracks.

2.Push each rack stop squarely into the end of the track until the catch pops into the small hole on the side of the track.

8