MAINTENANCE
Oven Door
CAUTION
NEVER place excessive weight on or stand on an open oven door. This could cause the range to tip over, break the door, or injure the user.
•NEVER attempt to open or close door or operate oven until door is properly replaced.
•NEVER place fingers between hinge and front oven frame. Hinge arms are spring mounted. If accidentally hit, the hinge will slam shut against oven frame and could injure your fingers.
Leveling Legs
CAUTION
Be sure the
Be sure the range is leveled when installed. If the range is not level, turn the leveling legs, located at each corner of the range, until range is level.
To remove:
1. When cool, open the oven door to the broil stop position (opened about four inches).
Oven Light
LEVELING LEG
2. Grasp door at each side. Do not use the door handle to lift door.
3. Lift up evenly until door clears hinge arms.
To replace:
1.Grasp door at each side.
2.Align slots in the door with the hinge arms on the range.
3.Slide the door down onto the hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.
Important: The oven door on a new range may feel “spongy” when it is closed. This is normal and will decrease with use.
Oven Window
To protect the oven door window:
1.Do not use abrasive cleaning agents such as steel wool scouring pads or powdered cleansers as they may scratch the glass.
2.Do not hit the glass with pots, pans, furniture, toys, or other objects.
3.Do not close the oven door until the oven racks are in place.
Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.
CAUTION
•Disconnect power to oven before replacing light bulb.
•Allow oven to cool before replacing light bulb.
•Make sure bulb cover and bulb are cool before touching.
To assure the proper replacement bulb is used, order bulb from
To Replace Oven Light Bulb:
1.Disconnect power to the wall oven.
2.When oven is cool, use fingertips to grasp edge of bulb cover. Pull out and remove.
3.Carefully remove old bulb by pulling straight out of ceramic base.
4.To avoid damaging or decreasing the life of the new bulb, do not touch the bulb with bare hands or fingers. Hold with a dry cloth or paper towel. Push new bulb prongs straight into small holes of ceramic base.
5.Replace bulb cover by snapping into place.
6.Reconnect power to the oven. Reset clock.
8
