Jenn-Air W10379136B manual Remove Trim Pieces, Install Door Panels, A A B B A, B A C, A B C

■Use the Standard Grille brackets for a Standard Integrated Grille Installation with a closed or open soffit.

A

B

A. Top grille brackets

B. Grille trim piece

2.Using round-head screws (provided with refrigerator), attach the grille trim piece to the bottom of the grill panel.

NOTE: The grille trim is preinstalled on the panel kits.

Remove Trim Pieces

1.Remove all tape and door bracing from the refrigerator and freezer doors.

2.Open the refrigerator and freezer doors.

3.Remove the hinge cover pieces from the top and bottom of the door to expose the holes in the hinges.

NOTE: It is not necessary to remove the hinge side trims as they will not interfere with the installation.

4.Remove the handle side trims. See the following graphic.

A

A

B B

A

A. Hinge cover pieces

B. Handle-side door trim

Install Door Panels

NOTE: First open the door opposite from the one to which you are installing the door panel.

1.Lower the panel mounting bracket onto the adjustment pins at the top of the door.

A

B

C

A. Door panel

B. Mounting bracket

C. Adjustment pins

2.Locate the studs on the back of the door panel. Slide the studs, top stud first followed by the bottom stud, into the “J” pockets in the front of the door.

NOTE: It is the washer in the stud, not the head of the stud, that is inserted in the “J” pocket.

3.Slide the door panel down, into the “J” pocket in the front of the door.

B

A

C

A. Washer in stud

B. “J” pocket

C.Stud

4.Repeat steps 1 through 3 to install the second door panel.

5.Using slotted hex-head screws (provided with refrigerator), attach the mounting bracket (factory installed), located at the bottom of the refrigerator and freezer doors, to the respective door panels. Do not fully tighten the screw.

AB

A. Bottom hinge

B. Mounting bracket

21