Install Top Grille Panel
BAB
A. Top grille panel
B. Cabinet sides
Standard Integrated Grille
1.Hook the panel brackets onto the mounting bolts extending from the top of the refrigerator.
A
B
A. Panel brackets
B. Grill trim piece
2.Pull the grille panel down slightly to lock into place.
Fully Integrated Grille
1.Align the bracket on each side of the top grille panel with the mounting bolts.
2.Push the grille panel forward until the bracket snaps into place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door. Make sure the refrigerator door(s) can open freely. If the door(s) opens too wide, install the door stop pin (provided with refrigerator).
1.Hold the door open to a position that is less than 90°.
2.Insert the door stop pin into the top hinge in the hole shown.
3.Using a ⁵⁄₃₂" hex key, tighten the door stop pin.
A
A. Door stop pin hole
Complete Installation
1.Use the installation block to measure the gaps between the panels and adjacent cabinets.
■Custom wood overlay panels may be made with a ³⁄₈" (0.95 cm) or ¹⁄₈" (0.32 cm) gap between the panel and cabinets and a ¹⁄₈" (0.32 cm) gap between the freezer and refrigerator door(s) and the door(s) and top grille.
■All purchased panel kits require a ³⁄₈" (0.95 cm) gap between the panel and the cabinets and a ¹⁄₈" (0.32 cm) gap between the freezer and refrigerator door(s), and the door(s) and top grille.
A
C
B
A. Adjacent cabinet
B. Installation block
C. Panel on door
2.Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel not the door. Adjust left to right in the mounting bracket before using the pins to adjust the panel up and down or at an angle.
■ Slide the panel from side to side in the keyhole slot.
22