Jenn-Air W10379136B Predrill Panels custom wood panels only, Predrill Panels panel kits only

Predrill Panels (custom wood panels only)

IMPORTANT: The custom panel template shipped with the refrigerator can be used for either a ³⁄₈" (0.95 cm) or a ¹⁄₈" (0.32 cm) reveal installation.

■The drilling templates are used only for custom wood overlay panels.

■The drilling templates are double-sided.

■The drilling holes are precut into the template.

1.On the template, locate the diagram of your refrigerator. Then, follow the letters and colored arrows to correctly place the drilling template on the back side panels.

NOTE: Check the direction of the arrows to determine which holes to mark when the template is aligned at the top of the panel and which holes to mark when the template is aligned at the bottom of the panel.

2.Predrill ¹⁄₈" (0.32 cm) deep pilot holes into the wood rails bordering the doors and top grille panels.

Predrill Panels (panel kits only)

IMPORTANT: The panels included in the panel kits are marked for the location of the mounting brackets only.

1.Predrill holes where marked. See “Complete Installation” later in this section, for instructions on drilling additional holes in the door panels.

2.Peel back the film cover on the door panel in the area of the brackets and handle studs. Do not fully remove the film covering until the installation is complete.

Prepare Panels (custom wood and panel kits)

IMPORTANT: The process for installing panels on the refrigerator is the same for both custom panels and panel kits.

Door Panels

1.Place panels on a firm, covered, flat surface with the front facing down.

2.Locate the 2 predrilled holes in the handle side edge of the door panel.

3.Using the installation block as a guide for depth, screw the door studs (provided with refrigerator) into the predrilled door panel (2 door studs per door).

A

B

4.For the mounting bracket, insert the hex-head pointed screws (provided with refrigerator) into the wood at the top of the door panels where they were predrilled.

NOTES:

■It is critical to use the ⁵⁄₈" screw, the longest length provided, to attach the bracket to the top of the door panel. These hex-head pointed screws are used only to attach this mounting bracket.

■Panel Kits—Insert the hex-head pointed screws into the slots in the door panel, not the U-shaped holes.

A

B

A.U-shapped hole

B.Slot

5.Attach a mounting bracket to the top edge of each door panel by placing the large end of the keyhole slot over the screws and sliding the bracket so that the screws are centered in the slots.

NOTE: Start with the screws in the center of the slots as shown, then move the door panel, as necessary, to align.

A B

A. Door panel

B. Mounting bracket

Top Grille Panel

1.Using the slotted hex-head screws (provided with refrigerator), attach a mounting bracket to each side of the top grille panel.

IMPORTANT: See the “Parts Provided” section to select the brackets designated for your installation.

■Use the Integrated Grille brackets for a Fully Integrated Grille installation with a full height grille.

A. Door stud

B. Installation block

20