Jenn-Air W10379136B Location Requirements, Opening Dimensions, Width A as shown, Dimension B as

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator.

Failure to do so can result in death, explosion, or fire.

IMPORTANT:

B

Dimension

84" (213.4 cm)

to bottom of solid soffit

■Observe all governing codes and ordinances.

■It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source.

	77"
■ Do not install in a location where the temperature will fall
	(196 cm)
below 55°F (13°C).

■ Floor must support the refrigerator weight, more than 600 lbs
(272 kg), door panels and contents of the refrigerator.		A
Flooring under refrigerator must be at same level as the room.		Width
	(see chart following)
Face of cabinetry must be plumb.
■ Ceiling height must allow for side tipping radius. See “Tipping
Radius.”
■ Location should permit door to open fully. See “Door Swing
Dimensions.”
■ Location must permit top grille removal. See “Opening
Dimensions.”

Opening Dimensions
IMPORTANT:
				C	Dep	th
■ The width of the opening (Width A), from side to side, must be
as specified for your model, for at least 2" (5.08 cm) back
from the face of the cabinet.
NOTE: If your opening does not meet this requirement, you
will need to make modifications.			Width A (as shown				Dimension B (as
■ A solid soffit or wall cabinet must be installed 84" (213.4 cm)		Model	above)				shown above)
above the floor. If the solid soffit is higher than 84" (213.4 cm)
	42		42" (106.7 cm)				10" (25.4 cm)
or one is not available, then the refrigerator must be braced.
	48		48" (121.9 cm)				16" (40.6 cm)
If the anti-tip boards are needed, they must be attached to
the rear wall studs so that there is 84" (213.4 cm) from the
		Installation Type					Depth C (as shown above)
bottom of the anti-tip board to the floor. See “Install Anti-Tip
Boards” for more information.		Standard Flush					25" (63.5 cm) minimum
■ For a fully integrated installation, a minimum of 6" (15.24 cm)
		(new installation)
of open space above the refrigerator is required. See “Fully
		Retrofit Installations					24" (60.9 cm) minimum
Integrated Installation.” Anti-tip boards are required. See

“Install Anti-Tip Boards” for more information.

■ A grounded 3 prong electrical outlet should be located within a specified number of inches from the right-hand side cabinets or end panel. See the chart following the graphic for the number of inches required for your model. For more information, see “Electrical Requirements.”

■ The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the plumbing for the water line can come through the floor. See “Water Supply Requirements” for more information.

7