![Complete Installation](/images/new-backgrounds/60416/6041643x1.webp)
Complete Installation
1.Insert downdraft vent filter and place vent cover over opening.
B
A
A.Filter
B.Grate
2.Reconnect power.
3.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
4.Check that you have all of your tools.
5.Dispose of/recycle all packaging materials.
6.Check that the range is level. See “Level Range.”
7.Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, read the “Range Care” section of the Use and Care Guide.
8.Read “Range Use” in the range Use and Care Guide.
9.Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation.
If range does not operate, check the following:
■Household fuse is intact and tight; or circuit breaker has not tripped.
■Range is plugged into a grounded outlet.
■Electrical supply is connected.
■See “Troubleshooting” in the Use and Care Guide.
When the range has been on for 5 minutes, check for heat. If range is cold, turn off the range and contact a qualified technician.
10.Use the Flow Tester Card provided with your range to check the air flow (see card for step by step instructions).
If there is not sufficient air flow, review the “Venting Requirements” and “Venting Methods” sections.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your range.
Moving the Range
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install
Slide range back so rear range foot is engaged in the slot of the
Do not operate range without
Failure to follow these instructions can result in death or serious burns to children and adults.
When moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
For power supply cord-connected ranges:
1.Disconnect range from downdraft vent system.
2.Slide range forward.
3.Unplug the power supply cord.
4.Complete cleaning or maintenance.
5.Plug power supply cord into a grounded outlet.
6.To check that
■Look for the
■Slide range back so rear range foot is under
7.Check that range is level.
8.Reconnect range to downdraft vent system.
22