Style 2: Direct wire strain relief
■Use Phillips screwdriver to remove screws from panel on back of range.
■Lift range back panel up and off.
■Use Phillips screwdriver to remove screws and slide cord/conduit plate down and out.
■Position cord/conduit plate as shown in the following illustration.
■Replace cord/conduit plate and insert screws.
■Assemble a UL listed conduit connector in the opening.
A
B
A. Removable retaining nut
B. Strain relief
■Feed the flexible conduit through the strain relief, allowing enough slack to easily attach wiring to the terminal block.
■Tighten strain relief screw against the flexible conduit.
5.Replace back panel and screws on rear of range.
6.Complete installation following instructions for your type of electrical connection:
15