AMX NXD-CV5 manual Install the 3 included drywall clip sets into these locations

Installation

Install the 3 included drywall clip sets into these locations

A - Faceplate

/Trim Ring

3 notches are required to accommodate the three expansion clips (included)

Drywall Clip (3)

Mounting Tab

B - Main NXD unit consists of the touch panel and back box

FIG. 20 Wall Mount panel (NXD) installation configuration for drywall surfaces

Don’t disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before being inserted into the drywall.

8.Install the three sets of drywall screws and expansion clips into the three oval notch locations along both sides of the main unit (B in FIG. 20).

9.Carefully insert the main unit (with expansion clips) into the cutout until the Mounting Tabs on the NXD unit lie flush against the wall.

The drywall clip set must be re-ordered from AMX if the drywall clip is bent accidentally during an installation or removed during a re-installation.

10.Tighten all three drywall clip sets (screws and clips) until the entire Mounting Tab is securely fastened and flush against the wall.

11.Place the Faceplate/Trim Ring assembly (A in FIG. 20) back onto the main NXD unit

(B in FIG. 20). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front faceplate/bezel.

12.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.

13.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

24 5" Modero Widescreen Touch Panel