AMX NXD-CV5 manual Installation, Unpacking the Panel, Installing the No-Button Trim Ring

Installation

Installation

This NXD panels can be installed into either a pre-wall surface (using a CB-TP5 rough-in/wallbox) or a solid surface (using either solid surface or drywall screws).

Unpacking the Panel

1.Inspect and confirm the contents of the shipment box to verify you have all specified parts. Refer to the Specifications for 5" Widescreen Video Touch Panel section on page 2 for more information about included accessories and other AMX equipment.

2.Carefully remove the panel from the shipping box.

3.Carefully peel the protective plastic cover from the LCD.

If the protective plastic LCD cover is not removed, the panel may not respond properly to touch points on the LCD or allow proper screen calibration.

Installing the No-Button Trim Ring

The NXD-CV5 panel is shipped from AMX with the default Button Trim Ring already installed. The unit is also shipped with an included Trim Ring containing no button openings (a No-Button Trim Ring) that allows you, if desired, to change the default configuration of the NXD panel Faceplate to that with no-button openings. In order to install this included No-Button Trim Ring, you must first remove the factory-installed default Button Trim Ring and its six small buttons.

1.The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.

2.Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 10).

3.In a single motion, press down and then outwards on the two Trim Ring latches located along the top of the internal surface of the Faceplate to begin removing the Button Trim Ring. Removing the Internal Faceplate from the panel exposes the pushbuttons along the inside of the Internal Faceplate.

4.Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove it from the Faceplate (FIG. 10).

5.From along the internal surface of the Faceplate, remove the six buttons by gently bending each Button latch up and pulling the button outwards.

6.Grasp the No-Button Trim Ring on both sides and fit it into the groove along the outside surface of the Faceplate (made available by the removal of the previous Trim Ring).

7.Gently insert the Trim Ring latches into their corresponding openings on the outer surface of the internal Faceplate (FIG. 11).

5" Modero Widescreen Touch Panel 13