AMX NXD-CV5 manual Installing the Button Trim Ring, Removing the No-Button Trim Ring

Installation

Installing the Button Trim Ring

The outer No-Button Trim Ring is secured to the Faceplate with plastic latches. In order to re-install the Button Trim Ring back onto an NXD panel which has had the default Button Trim Ring features removed; you must first remove the No-Button Trim Ring:

1.To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.

2.Turn the Faceplate over to expose the inside surface and view the Trim Ring latches.

3.In a single motion, press down and then outwards on the two Trim Ring latches located along the top of the internal surface of the Faceplate to begin removing the Trim Ring. Removing the Internal Faceplate from the panel exposes the pushbuttons openings left from an earlier removal of the pushbuttons.

4.Gently tug along the edges of the No-Button Trim Ring and work your way around the edges to remove it from the Faceplate (FIG. 12).

Trim

Ring

Latches

No-Button Trim Ring

Faceplate (outside surface shown)

FIG. 12 Removing the No-Button Trim Ring

CV5 Panel/enclosure

Button latch

Button installation

(showing the internal surface of Faceplate)

5.From along the internal surface of the Faceplate, install the six buttons by firmly inserting them into the button openings until the Button latch secures the button in place (FIG. 12).

6.Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of the Faceplate (made available by the removal of the previous Trim Ring).

7.Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of the internal Faceplate (FIG. 13).

8.Firmly press down around the Button Trim Ring until all of the latches are securely inserted into their openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify the Button Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring and the outer surface of the Faceplate.

9.Place the Faceplate back onto the main NXD-CV5 unit. Make sure to align the Microphone, Light, and PIR Motion sensor locations on the main unit to their respective openings on the Faceplate assembly.

5" Modero Widescreen Touch Panel 15