AMX NXD-CV5 Installation of an NXD Touch Panel, Installing the NXD panel within a Rough-In Box

Installation

Stud Mounting tabs

Wiring knockouts (6)

(must be located on left side)

Drywall or sheetrock

FIG. 17 CB-TP5 rough-in box components

Stud

NXD Mounting tabs (should lie flush against the outside of the wall)

Remember that when mounting this rough-in box, the NXD mounting tabs must lie flush against the outside of the sheetrock.

4.Thread the incoming power, RJ-45 audio/video, Ethernet, and USB wiring through the knockouts (use of the left wiring knockouts are recommended with this installation).

Leave enough slack in the wiring to accommodate any re-positioning of the panel.

5.Install the drywall/sheetrock before inserting the main NXD unit into the CB-TP5.

Installation of an NXD Touch Panel

The NXD-CV5 can be installed either directly into the (optional) CB-TP5 or other solid surface environment using the two different mounting options: drywall clips or solid surface screws. The following sections describe mounting the touch panel directly into a pre-wall rough-in box, a solid surface or drywall, and optional NXA-RK5 Rack Mount Kit.

Installing the NXD panel within a Rough-In Box

The rough-in box must be mounted prior to continuing this section. Refer to the procedures in the Pre-Wall Installation of the Rough-In Box section on page 19 for detailed pre-wall installation instructions. Verify that all necessary cables have been threaded through the knockouts on the left of the rough-in box and the connections have been tested prior to installation of the NXD-CV5.

1.Remove the Faceplate/bezel (A in FIG. 18) from the main NXD unit (B in FIG. 18) by gripping the faceplate and pulling with gentle outward force.

2.Verify the incoming power, RJ-45 audio/video, Ethernet, and USB cables have been properly threaded through the wiring knockouts on the left of the rough-in box. Leave enough slack in the wiring to accommodate any re-positioning of the panel.

20 5" Modero Widescreen Touch Panel