AMX NXD-CV5 Specifications for 5 Widescreen Video Touch Panel Cont, Introduction, Viewing Angles

Introduction

Specifications for 5" Widescreen Video Touch Panel (Cont.)

Viewing Angles:	• 90° total viewing angle:
	- Horizontal: + 45° (left and right from center)
IR Reception Angle:	• Horizontal: + 25° (left and right from center)
	• Vertical: + 15° (up and down from center)
Supported Audio Sample	• 48000Hz, 44100Hz, 32000Hz, 24000Hz, 22050Hz, 16000Hz, 12000Hz,
Rates:	11025Hz, and 8000Hz.
Front Panel Components:
Light sensor:	• Photosensitive light detector for automatic adjustment of the panel brightness
	(a dim room results in a dimmer LCD display, and a bright room results in a
	brighter LCD display).
	Note: The light sensor can be adjusted via the Sensor Setup page (page 78).
Motion sensor (PIR):
	• Proximity Infrared Detector to wake the panel when the panel is approached.
	• Activation range: + 25° (left and right from center) and + 15° (up and down
	from center).
	Note: This sensor can be adjusted via the Sensor Setup page (see page 78).
IR Receiver:
	• IR reception 38 KHz and 455 KHz IR frequencies.
	• The IR receiver is located beneath the translucent Front Setup button. When
	an IR code is detected it is sent to the NetLinx Master as a push on the
	appropriate AMX IR channel.
	• IR receivers and transmitters on G4 panels share the device address number
	of the panel.
Front setup access button:
	• Provides both access to the Setup and Calibration page and toggles the
	panel between a "sleep" or "wake" state.
	- When wired, "sleep" status means the backlight is Off.
	- When battery operated, wireless "sleep" status means the touch panel
	base is either Off or "suspended".
Microphone:
	• Used for intercom applications
	(requires the NXA-AVB/ETHERNET Breakout Box for analog
	communication)
Speakers:
	• Stereo output with a frequency response of 500 Hz - 7 KHz
Buttons:
	• 6 programmable pushbuttons
Side Panel Components:
PWR connector:	• 2-pin 3.5 mm mini-Phoenix connector.
Ethernet 10/100 port:
	• RJ-45 port for 10/100 Mbps communication. The Ethernet port automatically
	negotiates the connection speed (10 Mbps or 100 Mbps), and whether to use
	half duplex or full duplex mode.
	• CV5 panels communicate with the NetLinx Master using the ICSP protocol
	over Ethernet.
Ethernet 10/100 LEDs:
	• LEDs show communication activity and connection information:
	A-activity - Yellow LED lights when receiving or transmitting Ethernet data
	packets.
	L-link - Green LED lights when the Ethernet cables are connected and
	terminated correctly.
Stereo Output connector:
	• Stereo output through a 3.5mm mini-jack (for use with external speakers or
	headphones).

5" Modero Widescreen Touch Panel 3