AMX NXD-CV5 manual the touch panel and back box housing

Installation

C - Optional CB-TP5	Stud
rough-in/wallbox

#4-40 Mounting Screws

(three - included)

secure the NXD to

the Rough-In Box

Mounting Tab

B - Main NXD unit consists of

the touch panel and back box housing

A - Faceplate/Trim Ring

default Faceplate comes with buttons

FIG. 18 NXD-CV5 panel installation into a CB-TP5 (pre-wall construction)

3.Connect all data and power wiring connectors to their corresponding locations along the side of the (un-powered) NXD touch panel.

Verify that the terminal end of the power cable is not connected to a power source before plugging in the 2-pin power connector.

The USB connectors can be from either a USB extension cable, or a wireless USB RF transmitter.

4.Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify that the panel is receiving power and functioning properly to prevent repetition of the installation.

5.Disconnect the terminal end of the power cable from the connected power supply.

Don’t disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before being inserted into the rough-in box.

6.Carefully slide the main NXD-CV5 unit (B in FIG. 18) into the rough-in box, so that all Mounting Tabs lie flush against the rough-in box (C in FIG. 18).

7.Insert and secure three #4-40 Mounting Screws (included) into their corresponding holes located along the sides of the NXD.

8.Place the Faceplate/Trim Ring (A in FIG. 18) back onto the main NXD unit (B in FIG. 18). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front faceplate/bezel.

9.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations (outside the rough-in box) on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.

5" Modero Widescreen Touch Panel 21