AMX NXD-CV5 to setting up a USB connection to the panel, USB driver installation popup window

Configuring Communication

No connection is established until the Virtual Master becomes active within Studio

Red Connection Status icon - indicates no connection to a Virtual Master

Green Connection Status icon - indicates communication to a Virtual Master

FIG. 33 USB System Connection page - using a USB Connection Type

ALL fields are then greyed-out and read-only, but still display any previous network information.

6.Press the Back button on the touch panel to return to the Protected Setup page.

7.Press the on-screen Reboot button to both save any changes and restart the panel. Remember that the panel’s connection type must be set to USB prior to rebooting the panel and prior to inserting the USB connector.

8.ONLY AFTER the unit displays the first panel page, THEN insert the mini-USB connector into the Program Port on the panel. It may take a minute for the panel to detect the new connection and send a signal to the PC (indicated by a green System Connection icon). If this is your first time installing the USB driver, a USB driver installation popup window (FIG. 34) appears on the PC.

FIG. 34 USB driver installation popup window

This window notifies you that the panel has been detected by the PC as a USB-compliant device and the PC is installing an appropriate USB driver to establish a proper communication to the panel.

This driver was installed on your PC during the installation of the latest NetLinx Studio and TPDesign4 software application installations. These applications should be installed prior

to setting up a USB connection to the panel.

36 5" Modero Widescreen Touch Panel