AMX NXD-CV5 manual USB Port Connecting and Using Input Devices

Installation

FIG. 25 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and cable.

FIG. 25 RJ-45 wiring diagram

USB Port: Connecting and Using Input Devices

The CV5 panel can have up to two USB-capable input devices connected for use on its different firmware and TPD4 panel pages. These input devices can consist of a keyboard or mouse.

USB-connected input devices are not detected and recognized by the panel until power is cycled to the unit.

A mini-USB connection is only detected after it is installed onto an active panel. Connection to a previously powered panel, allows the PC to detect the panel and assign an appropriate USB driver.

1.Insert the input device USB connectors into the appropriate USB connector on the panel.

2.Press the on-screen Reboot button from the Protected Setup page to save any changes and restart the panel.

3.After the panel splash-screen disappears:

If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location corresponds to the mouse cursor position sent by the external USB mouse.

If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any external keystrokes sent from the external USB keyboard.

30 5" Modero Widescreen Touch Panel