AMX NXD-CV5 manual Pre-Wall Installation of the Rough-In Box

Installation

No-Button Trim Ring

Hollow button openings

Faceplate (outer surface shown)

FIG. 16 Installing the No-Button Bezel Kit (NXA-BEZ-5NB)

Pre-Wall Installation of the Rough-In Box

Wall Mount panels (NXDs) are contained within an outer housing (back box). This back box is not removed when installing the NXD into a CB-TP5 Rough-In Box. The back box is only removed to gain access for the replacement of the internal components.

INSTALLER: LEAVE A GAP BETWEEN THE STUD AND ROUGH-IN BOX MOUNTING TABS TO ACCOMMODATE THE DRYWALL or SHEETROCK.

This gap allows the installation of the drywall or sheetrock after the CB-TP5 Rough-In Box has been installed.

The CB-TP5 is an optional metallic box that is secured onto a stud/beam in a pre-wallsetting (where no walls are present). Installation procedures and configurations can vary depending on the installation environment. This section describes the installation procedures for the most common installation scenario. The most important thing to remember when mounting this rough-in box is that the NXD-CV5 Mounting Tabs must lie flush against the outside of the sheetrock (FIG. 17).

Refer to SP-2261-01for detailed installation dimensions.

It is recommended that you cut out the surface slightly smaller than what is outlined in the installation drawings so that you can make any necessary cutout adjustments.

The wiring knockouts on the left side will be used for the NXD-CV5 Wall Mount panel connectors, so always secure the rough-in box to the stud using the Stud Mounting Holes on the right side of the box.

1.Rest the right Stud Mounting tabs onto the stud (keeping the knockouts on the left). Be sure to leave enough of a gap between the stud and NXD Mounting tabs to accommodate the installation of the drywall or sheetrock after the rough-in box has been mounted. Ultimately, the Mounting Tabs should lie flush against the outside of the sheetrock.

2.Fasten the CB-TP5 rough-in box to the stud through the holes on the right Stud Mounting tabs (FIG. 17), using either nails or screws.

3.Remove the wiring knockouts from the left side of the rough-in box (CB-TP5) (FIG. 17) to accommodate the cables being threaded through to the NXD touch panel.

5" Modero Widescreen Touch Panel 19