Jet Tools GH-1340W, GH-1440W owner manual Coolant Preparation, Electrical Connections

Coolant Preparation

CAUTION

Follow￿coolant manufacturer's recommendations for use, care, and disposal.

1. Remove rear access cover on tailstock end. Make sure coolant tank has not shifted during transport and is located properly under the recovery chute (Fig. 9).

2. Pour three gallons of coolant mix into drip pan.

3. After machine has been connected to power, turn on coolant pump and check to see coolant is cycling properly.

4. Fasten coolant door to stand.

Electrical Connections

WARNING

All electrical￿connections must be completed by a qualified electrician!

Failure to comply may cause serious injury

and / or damage to the machinery and

property!

The GH-1340W-1 & GH-1440W-1 Gear Head Lathes are rated at 3HP, 1Ph, 230V only. Confirm power available at the lathe's location is the same rating as the lathe.

The GH-1340W-3 & GH-1440W-3 Gear Head Lathes are rated at 3HP, 3Ph, 230V/460V prewired 230V. Confirm power available at the lathe's location is the same rating as the lathe.

Lathe Power Source Junction Box: Remove the cover. Run the main power through the strain relief bushing and attach the ground, followed by power leads. Replace the cover.

Main Power Switch: Located on the backside of the machine. Turns the power to the machine on and off.

11