Power Supply (Each power supply includes internal cooling fan)
Quantity: 2
Power: 430 Watts each (N+1) Power Factor Correction
Input: 100-260 VAC; 50-60Hz
Output: +5V @ 35A
+12V @ 30A
Blower
Quantity: 2
Size: 97mm (3.82") each
Air Flow: 25.42CFM (0.72m3/min) each
Noise: 52dB(A)
SCSI Features

Tri Channel

The 10-bay SCSI RAID with G5312 both Tower and Rackmount enclosures have
a tri SCSI bus configuration with five drive bays on internal bus A and five drive
bays on internal bus B. In addition, there are two external connections for SCSI
host bus connection IN and OUT.

Automatic Built-In Termination

The unit provides automatic dual-mode SE/LVD termination enable and disable
for any Single-Ended or LVD SCSI devices installed in the unit.

ID Selection

Standard default ID's are pre-configured as follows:
Channel A: ID 0, 1, 2, 3, 4
Channel B: ID 0, 1, 2, 3, 4
SAF-TE: Channel A, ID 5 (Optional)

SAF-TE

The SAF-TE command set is supported by the SAF-TE board installed in the unit.
Host setup software is included and is supported under Dos 5.0+, Windows 95,
and Windows 98. Boot disk must load DOS SCSI drivers from autoexec.bat and
config.sys. Host bus adapter ASPI drivers are required to run the test software.
The software is not needed for SAF-TE to operate. The processor will operate
normally without user intervention as long as the host bus adapter or RAID
controller supports the SAF-TE protocol.
FORTRAH1 Chaparral G5312 InstallationGuide Rev C 1-3