Brick Panel Assembly
Install the optional Brick Panels before placing the Logset. Place the panels in position in the order as numbered in fig. 37. No fasteners or tools are required.
Upper Rear Panel,
220031
4
Left Side | 1 |
| 2 | Right Side |
Panel, |
| |||
3 | Panel, | |||
220997 |
|
| 220996 |
Lower Rear Panel,
220030
Pull Frame Latches to
Release Frame
Figure 38. Glass Frame latch locations.
Figure 37. Panel installation order.
1.Remove the Glass Frame, if you have not already done so. Open the lower control panel and locate the two frame latches under the firebox floor. See fig. 38 . Pull the latch handle forward to disengage it from the bottom of the glass frame. You can then pull the frame out and up off of the three retainer tabs at the top of the firebox opening. Set the Glass Frame out of the way.
2.Remove the Fettle and Logset. These parts are not fastened. Simply lift them out of the firebox.
3.Install the Side Panels. Set the bottom edge of each side panel on the Burner Skirt and against the firebox wall. Push the panel forward against the front lip of the firebox opening. See fig. 39.
4.Install the Lower Rear Panel. Orient the panel so that the beveled edge is on top and the mortar joints align with those on the side panels. Set the bottom edge on the shelf above the restrictor adjustment slots at the back of the firebox. The panel should fit snugly between the two side panels. See fig. 40.
5.Install the Upper Rear Panel. This will also be a snug fit. Set the panel up high and then carefully lower it to seat its lower edge against the top of the other rear panel. The side panels will hold it in place.
Burner Skirt
Figure 39. Install the Side Panels.
Bevelled Edge
Side Panel
Figure 40. Install Lower Rear Panel.
20
