Jotul GZ 550 DV II manual Logset Assembly, CAUTION The logs are fragile. Handle with care

Logset Assembly

Unpack and arrange the five logs as outlined below.

CAUTION: The logs are fragile. Handle with care.

1.Seat Right Log (1) on the pin on the right side of the Burner Skirt. fig. 41.

2.Set Rear Log (2) on the pins at the rear of the Burner Skirt. This log should overlap the back of the Right Log.

3.Set the Left Log (3) on the pins at the left side of the Burner Skirt.

4.Set the end of Front Log (4) into the pocket at the rear of Left Log (3). Engage the other end with the pin in the middle of the Burner Plate. Fig. 42.

5.Engage the upper end of the Cross-over Log (5) with the pin in the Rear Log. Fig. 42. Set the Cross-over Log across the top of the lower end of the Front Log (4) as illustrated.

6.Spread a layer of ember stones evenly over the surface of the Burner Plate. Allow for 1/4” clearance between the stones and the inner edge of the Burner Skirt. Avoid blocking the pilot flame area with ember stones. See Fig. 43.

7.Replace the Glass Panel Frame: Engage the top of the frame with the three tabs at the top of the firebox. Push the bottom of the frame against the firebox face and pull the Frame Latches out to engage them with the slots in the bottom of the frame.

3	1
	2

Figure 41. Install Right Log, Rear Log and Left Log in that order.

5

4

Figure 42. Install Front and Cross-over logs as shown.

Pilot

Area

Figure 43. Install ember stones, keeping clearance around the pilot crossover area.

21