Table of Contents
Specifications | 4 |
Installation / Service Tools | 5 |
General Information | 5 |
Safety Information | 6 |
Installation Requirements |
|
Framing | 6 |
Mantel Clearances | 8 |
Hearth Protection | 8 |
Vent Requirements | 9 |
Vertical Termination | 10 |
Horizontal Termination | 11 |
Terminal Clearances | 11 |
Vent Restrictor | 12 |
Fireplace Assembly |
|
Blower Installation | 12 |
Gas Connection | 14 |
Gas Pressure | 14 |
High Altitude Adjustment | 15 |
Fuel Conversion | 16 |
Wall Thermostat | 19 |
Remote Control | 19 |
Antique Brick Kit | 20 |
Log Set Installation | 21 |
Surround Assembly | 22 |
Double Door Installation | 22 |
System Check | 23 |
Operation | 25 |
Maintenance | 26 |
Glass Replacement | 26 |
Service Log | 27 |
Illustrated Parts Breakdown | 28 |
Replacement Parts List | 29 |
Accessories | 30 |
Lighting Instructions .... Back Cover | |
Unpacking the Fireplace
1.Before you remove the carton, remove the cast iron parts that are packed around the fireplace cabinet.
2.Lift the shipping carton off of the fireplace cabinet.
3.Unpack the Firebox. The Logset is packaged inside the firebox. Remove the Glass Panel Frame to unpack the firebox:
•Locate the right and left spring latches on the underside of the firebox floor. Release each latch by pulling them forward to disengage the frame body.
•Pull the Glass Frame away from the firebox and lift to disengage it from the three steel tabs located at the top of the firebox. Set the glass out of the way.
Do not unpack the logs until you are ready to install them.
Spring Latches
| BLOWER |
| BURNER |
| IGNITOR | ON | HI |
| MANUAL |
| MANUAL |
| OFF |
| OFF |
| AUTO | OFF | AUTO |
HI | LO |
| LO |
Pull each Spring Latch to disengage them from the Glass Frame.
PLEASE READ THESE INSTRUCTIONS IN
THEIR ENTIRETY AND MAKE THEM AVAILABLE TO ANYONE USING OR SERVICING THIS APPLIANCE.
3
