Jura Capresso 13709 manual Drawing off pre-ground coffee, Drawing off hot water

10. Drawing off pre-ground coffee

Never use instant coffee or quick-coffee. We recommend that you always use powder from fresh coffee beans or, pre- ground, vacuum-packed coffee. Never fill in more than 2 portions of powder. The pre-ground coffee tank is no storage tank. Make sure that the pre-ground you use is not too fine. This may cause blocking of the system. In this case the coffee only drips out of the coffee spout.

If you have filled in too little powder, the message NOT ENOUGH POWDER will be displayed. The IMPRESSA stops the operation and returns to "ready for draw off" mode.

You can stop the draw-off operation at any time by pressing any coffee draw-off key.

 READY

Put 1 or 2 cups under the adjustable coffee spout (17).

Open the cover of the filler funnel for pre-ground coffee (11).

 FILL

POWDER

Fill 1 or 2 level spoonfuls of pre-ground coffee in the filler funnel for pre-ground coffee (11) (Fig. 10) and close the cover.

 SELECT

KEY

Press the required draw-off key.

 120 ML (water quantity last adjusted)

The illuminated ring (2) is active.

 COFFEE

Turn the Rotary Switch (1) again to select the water quantity individually:

For Example: 210 ML

 COFFEE

Your product is being prepared.

 READY

11. Drawing off hot water

The amount of hot water you used last is saved by the IMPRESSA until the next time you make coffee.

Install the hot water nozzle (see Fig. 5) to obtain perfect water flow. Do not replace the replaceable hot water nozzle

(16)directly after drawing off water, because the nozzle is hot after the draw-off operation.

At the start of the water draw-off operation there can be splashing Avoid direct contact with the skin!

 READY

Place a cup under the replaceable hot water nozzle (16).

Open the steam / hot water draw-off tap (14) (Fig. 12).

The illuminated ring (2) is active.

 STEAM

Touch the (8) symbol

For example, 140 ML

 WATER

Adjust the required water quantity by turning the rotary switch

(1).

For example, 200 ML

 WATER

If the required water quantity is reached, the following message is displayed:

12