Installation of Claris plus filter cartridges

5. Installation of Claris plus filter cartridges

If the Claris plus filter cartridge is installed properly, de- scaling of the coffee machine is no longer required. For more information on the Claris plus filter cartridge refer to brochure «Claris plus. Hard on limescale. Gentle on your coffee machine.»

5.1 Installing the filter

Draw off 1/2 litre of water to rinse filter completely. In order to ensure perfect operation, close tap (14) only after the dis- play says

CLOSE TAP

Fold up the cartridge holder. Install the filter cartridge in the water tank, applying a gentle pressure (Fig. 1).

Fold down the cartridge holder again until it engages audibly.

Fill the water tank with cold, fresh tap water and install it again.

Press the Rotary Switch (1) until

FILTER – / appears

FILTER –

Press the Rotary Switch (1) to start the programming.

NO –

Turn the Rotary Switch (1) until the following message is dis- played:

YES

Press the Rotary Switch (1) to activate the filter cartridge.

INSERT

OPEN TAP

Put a sufficiently large container (approx. 1 litre) under the replaceable hot water nozzle (16).

If not installed already, insert the Claris plus filter.

Open the steam / hot water draw-off tap (14) (Fig.12).

RINSING

FILTER

CLOSE TAP

Close the steam/hot water draw-off tap (14), now the IM- PRESSA will heat up to coffee temperature.

HEATING UP

READY

Now you have activated the filter. In Programming Mode the water hardness selection function is no longer displayed.

5.2 Replacing the filter

	Draw off 1/2 litre of water to rinse filter completely. In order
	to ensure perfect operation, close tap (14) only after the dis-	E
	play says
	CLOSE TAP
	CLOSE TAP

After drawing off approx. 50 litres, the filter cartridge will be used up. A message requesting you to replace the filter will appear on the display. The scale on the cartridge holder in the water tank will tell you how much longer you can use the CLARIS plus filters.

CHANGE FILTER / MACHINE READY