NOW, you can plug in the unit and other connected equipment FINALLY!
To a wall outlet
When connecting the AC power cord into a wall outlet, the unit automatically starts display demonstration.
•Pressing TITLE on the unit while the unit is turned on, shows the title entry screen (if there is no MD in the MD loading slot). You can experience how to select a character on this screen.
To stop and cancel the display demonstration, press ENTER/DEMO during display demonstration. “MODE OFF!” appears in the main display, the unit is turned off, then the display dims and “POWER SAVING” appears in the dimmed main display.
After canceling the display demonstration, it will start only when the AC power cord is reconnected or when a power failure is recovered.
•Pressing any button on the unit or the remote control stops the demonstration temporarily.
To start the display demonstration manually
See “Changing the Main Display Screen” on page 12.
Putting the Batteries into the Remote Control
Insert the batteries —
When the remote control can no longer operate the unit, replace both batteries at the same time.
1
2
3
If you do not cancel the display demonstration, it will start automatically in the following cases
•2 minutes after the unit is turned off.
•When no operation is done for more than 2 minutes after the unit is turned on.
If you do not want to start the display demonstration when the AC power cord is reconnected or when a power failure is recovered
See “To store the selected main display screen in backup memory” on page 13.
•DO NOT use an old battery together with a new one.
•DO NOT use different types of batteries together.
•DO NOT expose batteries to heat or flame.
•DO NOT leave the batteries in the battery compartment when you are not going to use the remote control for an extended period of time. Otherwise, it will be damaged from battery leakage.