Chapter 4—Setup Adjustments
4-42 Hughes-JVC Technology Corporation
6. Use the up/down arrows to select the VIC number (refer to Table 4.0-
6).
Table 4.0-6 VIC Edit Numbers
Input VIC
1.1 Standard RGBHV
2.1 Wide Bandwidth RGBHV
2.1 Graphics Enhancer RGBHV
2.1 to 2.4 Quad RGBHV Video Mux (multi-port)
2.1 or 2.2 Component HDTV (YPbPr) Input Module
2.1 or 2.2 Quad Standard Decoder Module (with Line Doubler)
7. Press the right arrow again to move to the second VIC column—use
the second column to select the VIC port # for the Quad RGBHV
Video Mux (multi-port) VIC, or the HDTV YPbPr VIC, and the YC or
C-VID input for the Quad Standard Decoder Module VIC.
Table 4.0-7 Optional VIC Port Numbers and LEDs
Port # VIC Input
1, 2, 3 or 4 Quad RGBHV Video Mux
(multi-port) The corresponding LED (1, 2, 3, or 4) will light
when the appropriate port is selected and the
channel and source are active.
1 or 2 Component HDTV
(YPbPr) Input Module #1 for [YPbPr] lights the corresponding LED on the
left side of the VIC panel.
#2 for [RGB] lights the corresponding LED on the
right side of the VIC panel.
1 or 2 Quad Standard Decoder
Module (with Line Doubler) #1 input for Y/C (S-video) lights the LED on the
left side when this channel is active.
#2 input for C-VID (Composite Video) lights the
right side LED when this channel is active
(labeled "Video").
NOTE: Only one (1) of these LEDs can light
at any one (1) time.
NOTE: When activating a Quad Standard Decoder Module VIC,
be sure to have a proper source connected to the inputs on the rear
panel. The projector will not select an appropriate source without a
proper input source.
8. The channel and an appropriate source should now be named and
edited in the CHANNELS LIST. This is covered in Section 4.4.1 on page
4-2 about Setup Preparation.
NOTE: If switchers are used with the projector, the switcher's port
number is edited in the third VIC column. Press the right arrow key to
access the third column, press ENTER and use the up/down keys to
select a switcher port #.