JVC CB100 manual Terminal Preference Selections, Terminal Preferences

Chapter 4—Setup Adjustments

Table 4.0-9 Terminal Preference Selections

Terminal Preferences

Terminal Modes	=	Sound
CR#CR/LF	=	OFF
Columns	=	80
Cursor	=	Block and Blink
Terminal Font	=	Fixedsys 15
Translation	=	none
Show Scroll Bars	=	ON
Buffer Lines	=	100

Use Function Arrow

and Control keys for Windows = OFF

Select OK.

7.Under Settings select Text Transfer = Standard Flow Control. Select OK.

8.Under Settings select Communications and choose.

Table 4.0-10 Terminal Preference Selections

Connector	= PC port being used
Baud Rate	= 9600 or 19200 ∇
Data Bits	=	8
Stop Bits	=	1
Parity	=	none
Parity Check	=	OFF
Carrier Detect	=	OFF
Flow Control	=	XON/SOFF

∇Depends on the System Controller Switch Block:

Pos 4 ON = 9600 Pos 4 OFF = 19200

Select OK.

9.Press CTRL + SHIFT+_ to reboot the BOOT MANAGER. The Power On LED stays Red.

NOTE: The switch block at SW1 of the System Controller Board controls the baud rate for Serial Port A for the Boot Manager and System Software. This switch is factory-set ON for switch positions 1-4.

If new software will not load correctly and it becomes necessary to check this switch, contact HJT Field Service.

10.The following should be displayed on the WINDOWS TERMINAL screen (where x.x.0 is the currently loaded Boot Manager version [e.g. 1.3.0]).

4-46 Hughes-JVC Technology Corporation