JVC CU-VD10 Troubleshooting, Force Eject Lever, Procedure, Trouble Cause/Action

Troubleshooting

If you think there is a malfunction, first check the following items. If you are still unable to solve the problem, consult your local JVC dealer.

Trouble	Cause/Action
Cannot turn the power on.	● Make sure the AC adapter is connected properly.
	● Make sure the power switch is turned on.
The camera/PC is not recognized.	● Make sure the USB cable is connected properly.
The burner or AC adapter is hot.	● This is not a malfunction. If the burner is abnormally hot, remove the AC adapter and consult the
	dealer from which you purchased the burner.
Cannot open the disc tray.	● A disc cannot be ejected by pressing the eject button if data is being written to the disc. Wait until
	writing finishes.
	● If a disc cannot be ejected with the eject button because of a failure or a malfunction caused by,
	for example, the burner being dropped, use the force eject lever to eject the disc. (See below.)
Writing fails.	● Make sure an appropriate disc is being used. ( pg. 3, 4)
	● Use discs recommended for the burner. ( pg. 4)
	● Insert the disc with the label facing up.
	● Make sure the writing surface of the disc is not damaged.
	● Make sure the disc tray is not dirty.
	● Writing to irregularly shaped discs such as heart-shaped discs or octagonal discs is not possible.
	● Check the writing speed of the disc being used.
Reading fails.	● Insert the disc with the label facing up.
	● Make sure the writing surface of the disc is not damaged.
	● Writing to irregularly shaped discs such as heart-shaped discs or octagonal discs is not possible.
	● Any CD recorded using the packet-write method cannot be played.
	● Any CD that does not comply with standards such as the CD-DA standard (copy-control CDs)
	cannot be played.
Writing/reading at maximum speed	● Reading at maximum speed may not be possible if a nonstandard disc is used.
is not possible.	● Use discs recommended for the burner. ( pg. 4)
Commercial DVDs cannot be played	● Check the region code. ( pg. 3)
when the burner is connected to PC.
It is impossible to dub the DVD discs,	● Connect the burner to the camera, playback using [PLAY DVD] function of the camera, and dub
which were written with this burner,	the DVD discs with the DVD recorder.
with DVD recorder with HDD.	(Refer to “Connecting to a TV, VCR or DVD Recorder” or “Using a DVD Burner for Dubbing” in the
	camera's manual.)

Force Eject Lever

If a disc cannot be ejected with the eject button because of a malfunction caused by a power cut or the burner being dropped, use this lever to eject the disc.

Procedure

Use a Phillips screwdriver to open the cover at the bottom.

Move the lever inside from the right to the left.

EN 7