JVC 0307MNH-SW-BJ, CU-VD40U manuel dutilisation Troubleshooting, Trouble Cause/Action

Troubleshooting

Trouble	Cause/Action
General
Cannot turn the power on.	z Make sure the AC adapter and power cord are connected properly.
	z This is not a malfunction.
The burner or AC adapter is hot.	z If the burner is abnormally hot, remove the AC adapter and consult
	the dealer from which you purchased the burner.
After pressing the power button, it takes	z This is not a malfunction.
approximately 20 seconds before the burner
becomes operable.
Malfunction or error occurs.	z Turn the burner off, and then turn it back on again.
Saving
The Everio camera is not recognized.	z Make sure the USB cable is connected properly. Install the projected
	end of the terminal to the burner and the other end to the Everio
	camera.
The PC is not recognized.	z Make sure the USB cable provided for the Everio camera is connected
	properly.
	z A disc cannot be ejected by pressing the eject button if data is being
	written to the disc. Wait until writing finishes.
Cannot open the disc tray.	z If a disc cannot be ejected with the eject button because of a failure
	or a malfunction caused by, for example, the burner being dropped,
	insert a thin rod of about 10 cm long into the force eject hole to eject
	the disc. (0P11)
	z Insert the disc with the label facing up.
	z Make sure the disc tray is not dirty.
	z Make sure the writing surface of the disc is not damaged.
Reading fails.	z Make sure that special-shaped discs are not used.
	z Any CD that does not comply with standards such as the CD-DA
	standard (copy-control CDs) cannot be played.
	z For CD-R or CD-RW, make sure it is not recorded using the packet-
	write method.
	z Make sure an appropriate disc is being used. (0P25)
	z Use discs recommended for the burner. (0P26)
	z Make sure that a new disc is used for DVD-R.
Writing fails.	z Insert the disc with the label facing up.
	z Make sure the disc tray is not dirty.
	z Make sure the writing surface of the disc is not damaged.
	z Make sure that special-shaped discs are not used.
It is impossible to dub the DVD discs, which were	z Connect the burner to the Everio camera, playback using “PLAY
written with this burner, on a HDD-DVD recorder.	DVD” function of the camera, and dub the DVD discs with the DVD
	recorder. (Refer to the instruction manual of Everio.)
	z Make sure an appropriate disc is being used. (0P25)
Writing/reading at maximum speed is not possible	z Use discs recommended for the burner. (0P26)
(when connected to PC).	z Make sure a proper standard disc is being used. (Writing/reading at
	maximum speed may not possible if non-standard discs are used.)
Playback
	z Remove the batteries, insert them again and operate the remote
The remote control is not working.	control.
	z Replace with new batteries.
	z Operation may be prohibited due to the disc or other conditions.
Unable to operate.	z If the burner does not work at all, turn off the power and turn it on
	again. (It may not work properly due to lightning strike or static
	electricity.)

EN

FR

ES

23