JVC DLA-HD10KU/E manual What to do when these messages are displayed, Message, Cause Details

What to do when these messages are displayed

Message Cause (Details)

No Signal DVI-D

No device is connected to the [DVI] terminal.

The DVI-D cable is connected to the [DVI] terminal but there is no signal input.

NInput the video signals.

Out Of Range

A video signal that cannot be used with this unit has been input.

NInput 1080/50p or 1080/60p video signals.

not available

Upon pressing the [ZOOM T/W] or [FOCUS +/-] button when AZoom/FocusB of the AOptionsB menu is set to ALockB.

NSet AZoom/FocusB of the AOptionsB menu to AUnlockB.

		At the moment when the accumulated lamp time
		reaches 1900 hours, a ALamp replacementB message
		will be displayed.
Lamp replacement
		In addition, when the accumulated lamp time reaches
	EXIT	between 1900 hours to 2000 hours, the (Lamp
		replacement) message will be displayed each time the
		projector is turned on.
		● The message can be cleared by pressing any button on
		the remote control or this unit.
		NGet ready a new lamp (lamp unit) in advance or
		replace as soon as possible.
		The ALamp replacementB message will be displayed
		and the AWarningB word appears blinking when the
Lamp replacement
		accumulated lamp time exceeds 2000 hours.
Warning		The message can be cleared by pressing the [EXIT]
	EXIT	button. However, the same message will reappear every
		hour.
		When the accumulated lamp time exceeds 2000 hours,
		the unit cannot be turned on again once it is switched to
		the standby mode or turned off.
		If continuous projection is performed after 2000 hours,
		the unit will shut down upon exceeding 2010 hours and
		projection will be disabled.
		NInstall a new lamp (lamp unit) and reset the lamp time.
		(A Pages 35 - 38)

40