Controls and Features
Front Side / Top Surface / Right Side
|
| 1 |
1 |
| 2 |
|
| 3 |
7 |
|
|
|
| 4 |
6 | 1 | 5 |
1 Adjustable foot |
| 4 AC IN (power input) terminal |
It is set at the shortest position when shipped from the factory.Turn the foot to make the projector level. Adjustment can be made in the range of ±4° from the vertical and ±5° from the horizontal.
2Connector panel
For details, refer to “Connector Panel” on page 10.
3Air intake area (filter)
Air is taken in through this area to cool the
CAUTIONS
•Be careful as paper, cloth or soft cushion could be drawn in if placed nearby. Do not block the intake area, or heat may build up and could cause a fire.
•Clean the filter periodically. For details, refer to “Cleaning and Replacing the Filter” on page 59.
Deposition of dirt on the filter works to reduce the cooling effect, causing heat to build up inside, which could cause a fire or malfunction.
This is the power input terminal where the supplied power cord is connected. For details, refer to page 23.
5MAIN POWER switch
This is the main power switch. When it is turned on, the projector goes into
ON [ ❙ ]: The main power turns on.
OFF [‡]: The main power turns off.
6Remote sensor
When operating with the remote control, aim it toward this sensor. An additional remote sensor is provided on the back of the projector. The effective operating distance of the remote control is 10 m from each of the sensors. The effective operating range of angles is 50° left and right, and 15° up and down.
7Lens mount
Attach a projection lens separately sold to this mount.
For information on attaching the lens, consult the dealer or service center who performed the installation and adjustments of your projector.
6
