JVC DLA-M5000LU Basic Operations, Turning on the Power, Turning off the Power, Stopped running

Basic Operations

■Projector’s buttons

STAND BY indicator

OPERATE indicator

TEMP

STAND BY OPERATE LAMP EMERGENCY AV RGB

OPERATE button 2, 1

MAIN POWER switch 1, 2

■Remote control unit

QUICK
ALIGN.	OPERATE	OPERATE button
	AV HIDE
PRESET	PAGE BACK	2, 1
LENS LOCK	N
	M
	E
	N
	U/
UNLOCK	E
	T
	E
	R

AV RGB/COMPUTER

U T +

SHIFT ZOOM FOCUS

D W –

LENS

■Caution on extended projection:

When projection continues for an extended amount of time, be sure to allow the lamp to be turned off for at least two minutes for every 72 hours of continued projection.

If you do otherwise, the service life of the lamp may be severely affected.

The following describes the basic procedure for normal use of the projector.

1.Turning on the Power

1 Turn on the MAIN POWER switch of the projector.

ON [ ❙ ]:The main power turns on and the STAND BY indicator comes on.

Projector’s indicator

STAND BY

2Press the OPERATE button for one second or more.

(Or press the remote control’s OPERATE button for one second or more.)

•The OPERATE indicator comes on.

•About 30 seconds after the MAIN POWER switch is turned on, you can start projecting.

Remote control unit Projector

OPERATE

or

OPERATE

Note

•After the power is turned on, the screen may be jumbled for a few seconds, but this is not a malfunction.

■Turning off the Power

1Press the OPERATE button for one second or more.

(Or press the remote control’s OPERATE button for one second or more.)

•The STAND BY indicator changes to blinking, and the projector goes into cool-down mode.

Example of the projector’s button Projector

\

STAND BY

OPERATE

2Turn off the MAIN POWER switch after the cooling fans have

stopped running.

OFF [‡]: The MAIN POWER switch turns off and the STAND BY indicator goes off.

Projector

STAND BY

*Do not turn off the MAIN POWER switch during cool down mode (the STAND BY indicator blinking). About 10 minutes after the STAND BY indicator comes on steady (stand-by mode), the cooling fans (except the one for the light-source lamp power supply) will stop, and then turn off the MAIN POWER switch.

25