JVC DR-MH30B, DR-MH20B manual Manual Timer Programming, Relief Recording

Filename [DR-MH30EU_07Timer Recording.fm]
DR-MH30EU_00.book Page 48 Thursday, June 3, 2004 11:00 AM	Masterpage:Left+

48 EN TIMER RECORDING

	Manual Timer Programming	6 Press rt to select “START”, then press ENTER. Press rt to
		set the desired start time, then press ENTER.
		● Each press of rt advances/goes back the start time in 1-min.
You can programme this unit to timer-record as many as
		increments.
32 programmes.		● To advance/go back the start time in 30-min. increments, press and
If you do not know the PlusCode number for the programme you		hold rt.
wish to record, use the following procedure to set your unit to		7 Press rt to select “STOP”, then press ENTER. Press rt to
timer-record the programme.		set the desired stop time, then press ENTER.
		● Each press of rt advances/goes back the stop time in 1-min.
● Make sure that the unit’s built-in clock is set properly.		increments.
● Turn on the unit.		● To advance/go back the stop time in 30-min. increments, press and
● Turn on the TV and select the AV mode.		hold rt.
● Slide the TV/CABLE/SAT/DVD switch to DVD.		8 Press rt to select “TV PROG”, then press ENTER. Press rt
		to select the desired channel.

CABLE/DBS

TVDVD

9 Press rt to select “CONFIRM”, then press ENTER. 10 Set the other recording options as required.

●Refer to step 8 in “VIDEO Plus+® Timer Programming” ( pg. 46).

AUX	PROGRAMME
ENTER
	rtwe

11 Press rt to select “OK”, then press ENTER to access the Programme Confirmation screen.

12 Press w e to select “EXIT”, then press ENTER to complete timer programming.

●To programme another timer, press w e to select “CONTINUE”, then press

ENTER.

2PROGRAMME > CALENDAR PROG. (3/3)

			14/01/04 WED 22:30 - 23:00		BBC1
			GARDENING	[EDUCATION] FR360
				1:00	28:00
SELECT WITH [		]	INPUT TITLE	GARDENING
THEN PRESS [ENTER]			CATEGORY	EDUCATION
PRESS [PROGRAM]			VPS/PDC		OFF
TO EXIT			WEEKLY/DAILY	MON-FRI (FOR A WEEK)
PROGRAM	ENTER		REC MODE	FR360
				O K
EXIT	SELECT

1 Load a recordable disc if recording to DVD.

2 Press PROGRAMME to access the programme top screen.

3 Press rtw e to select “CALENDAR PR.”, then press ENTER.

●When “PROGRAMME FULL DELETE UNWANTED TIMER PROGRAMMES” appears on the TV screen, you need to cancel some of the reserved programmes. ( pg. 49)

4 Press rtw e to select the desired date, then press ENTER.

5 Press rt to select “RECORD
				PROGRAMME > CALENDAR PROG. (2/3)
			2
TO”, then press ENTER. Press
			14/01/04 WED 22:30 - 23:00				BBC1
rt to select the desired							[MISC. ] XP
recording deck, then press	SELECT WITH [ ]			RECORD TO		HDD
ENTER.	THEN PRESS [ENTER]			START		22:30
	PRESS [PROGRAM]			STOP		23:00
	TO EXIT
	[0]: SAT			TV PROG		BBC1
	PROGRAM	ENTER
	EXIT	SELECT			CONFIRM

●If “PROGRAMME OVERLAPPED” appears on the TV screen, see page 49.

NOTES:

●When two successive programmes are recorded on a DVD-RW disc with Manual Timer Programming function, the beginning of the second one may be left off the recording.

●If the copy limited programme is received during timer-recording, the unit enters Record Pause mode. Recording starts again if it is switched to a recordable broadcast during the time you programmed.

Satellite Receiver Users

To timer-record a satellite broadcast using Manual Timer Programming:

APerform “Satellite Receiver Control Setting” ( pg. 25).

BPerform “Manual Timer Programming” ( pg. 48). In step 8, press AUX to change “TV PROG” to “SAT”. Then press rt to enter the channel position for the satellite broadcast.

C Leave the satellite receiver’s power on.

Relief Recording

When a programme that is set for the DVD deck cannot be recorded properly, the programme is recorded to the HDD deck instead in the same recording mode as set.

●If the remaining capacity of the hard disc is not sufficient, the programme is recorded to the DVD deck until the remaining capacity of the DVD disc lasts.

●If “JUST” is selected for the recording mode, the current recording mode for the DVD deck is applied.

Page 48

Thursday, 3 June 2004 10:46