Filename [DR-MH30EU_04Name.fm]

 

DR-MH30EU_00.book Page 25 Thursday, June 3, 2004 11:00 AM

Masterpage:Right0

 

 

SAT CONTROL SET EN 25

Satellite Receiver Control Setting

The following procedure is required if you receive satellite channels

through a satellite receiver. Approximately 20 seconds before the

 

VIDEO Plus+ timer programming ( pg. 46) or Manual Timer

 

Satellite receiver

programming ( pg. 48) starts, the unit sets its input mode to “L-2”

and automatically switches the satellite receiver’s channels using

 

 

the provided Satellite Controller.

Satellite Controller

Your unit(provided) (suggested locations)

Transmitter Satellite Controller

(provided)

Satellite receiver

21-pin SCART cable (provided)

Back of unit

L-2 IN/DECODER

SAT CONTROL

CABLE/DBS

TV DVD

ENTER

rtwe

Installing Satellite Controller

1 Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.

2Fix securely using the adhesive strip attached on the back of the Satellite Controller.

3Be sure to connect the unit’s L-2 IN/DECODER connector to the satellite receiver’s 21-pin SCART connector.

NOTE:

When connecting your satellite receiver, refer to its instruction manual.

4 Connect the Satellite Controller to the SAT CONTROL connector on the rear panel.

Setting Satellite Receiver’s Brand And Channel

After installation, set the satellite receiver’s brand and channel correctly; otherwise, the Satellite Controller cannot work correctly.

Turn on the unit.

Turn on the TV and select the AV mode.

Slide the TV/CABLE/SAT/DVD switch to DVD.

1 Turn on the satellite receiver’s power.

 

 

 

2 Press SET UP to access the Main Menu screen.

 

 

3 Press w e to select “INITIAL SET UP”, then press ENTER.

4 Press w e to select “TUNER

DVD VIDEO SET UP HDD/DVD SET UP

FUNCTION SET UP

INITIAL SET UP

SET”, then press ENTER.

TUNER SET

CLOCK SET

 

 

5 Press rt w e to select “SAT

 

AUTO CH SET

MANUAL CH SET

 

 

 

 

 

CONTROL SET”, then press

 

 

 

 

ENTER.

 

SAT CONTROL SET

GUIDE PROG SET

 

 

 

11 12 13

 

6 Press rt to select “BRAND”,

 

 

 

 

 

 

 

then press ENTER.

SET UP

ENTER SELECT WITH [ ] THEN PRESS [ENTER]

 

PRESS [SET UP] TO EXIT

 

EXIT SELECT

7 Press rt to select the brand

code from the list on page 26, then press ENTER.

If the unit is in playback or recording mode, you cannot set the brand code.

8 Press rt to select “PROGRAMME”, then press ENTER.

9 Press rt to select one of the channel positions on the satellite receiver, then press ENTER.

You can select the channel position between 1 to 999.

10 Press rt to select “TEST”,

INITIAL SET UP > SAT CONTROL SET

 

then press ENTER. The unit enters

BRAND

73

the Test mode.

PROGRAMME

12

 

 

TEST

SET UP

ENTER

SELECT WITH [

] THEN PRESS [ENTER]

 

 

PRESS [SET UP] TO EXIT

EXIT SELECT

SET UP

Page 25

Thursday, 3 June 2004 10:46

Page 25
Image 25
JVC DR-MH20B, DR-MH30B manual Installing Satellite Controller, Setting Satellite Receiver’s Brand And Channel