Filename [DR-MH30EU_04Name.fm]
Masterpage:Left0

20 EN

Page 20 Thursday, 3 June 2004 10:46
INITIAL SETTINGS

Auto Channel Set/Auto Clock Set/Auto Guide Program

Number Set

1Press 1 on the unit or DVD 1 on the remote control to turn on
the unit. The Country Set display appears on the TV screen. The
AUTO SET/T-V LINK display appears on the TV screen.
2Press we to select “AUTO
SET”, then press ENTER. The
AUTO SET screen will appear.
A
TTENTION:
“AUTO” blinks on the front display
panel; do NOT press any button on
the unit or remote control until the
front display panel shows “– –:– –”
as illustrated on page 22.
●When you have connected the unit
to a TV offering T-V Link via a
fully-wired 21-pin SCART cable
(墌pg. 19) and the TV is turned
on, the unit automatically performs
the Preset Download (墌pg.21) even if you select “AUTO SET” for
Auto Set Up function.
NOTES:
●In areas where no TV station transmits a PDC (Programme Delivery
Control) signal, the unit can perform neither Auto Clock Set nor Auto
Guide Program Number Set.
●If there is a power cut, or if you press 1 or SET UP while Auto Set
Up is in progress, Auto Set Up will be interrupted; be sure to turn off
the unit power once and try again from step1.
●Auto Clock Set may not function properly depending on the reception
condition.
Auto Set Up
After the 1 button on the unit (or DVD 1 on the remote
control) is pressed for the first time to turn on the unit, the Auto
Set Up function sets the tuner channels, clock** and Guide
Program numbers automatically.
Before starting, make sure of the following:
●The TV aerial cable should be connected to the unit.
●The unit’s mains power cord should be connected to a mains
outlet.
●Turn on the TV and select the AV mode.
●Slide the TV/CABLE/SAT/DVD switch to DVD.
rtwe
DVD1
ENTER
CABLE/DBS
DVDTV
1
PRESS [SET UP] TO EXIT
ENTER
SELECT
EXIT
SET UP SELECT WITH [ ] THEN PRESS [ENTER]
INITIAL SET UP > AUTO CH SET
TEST MODE
AUTO SET T-V LINK
A
TTENTION:
Once you have performed Auto Set Up, even if the unit’s memory
backup has expired, all the stored stations and their Guide
Program numbers remain in the unit’s memory and the unit will
not perform Auto Set Up again. The unit only performs Auto
Clock Set when the unit is turned on.
If you have moved to a different area, perform each setting as
required.
●Tuner setting (墌pg.72)
●Clock setting (墌pg. 75)
If a new station starts broadcasting in your area, perform tuner
setting. (墌pg. 72)
After “Auto Set Up” is completed, perform “Monitor Set” on
page 24.
PRESS [SET UP] TO EXIT
ENTER
SELECT
EXIT
SET UP SELECT WITH [ ] THEN PRESS [ENTER]
INITIAL SET UP > AUTO SET
AUTO SET
PLEASE WAIT...
DR-MH30EU_00.book Page 20 Thursday, June 3, 2004 11:00 AM