Dell C6145 Command Line Interface for Setup Options, D4 Token Table Setup Option Description

Command Line Interface for Setup Options

The options of SETUP menu allow users to control by system configuration utility (syscfg). The utility is included in Dell OpenManage Deployment Toolkit (DTK).

Users can use the utility as following:

•To change the SETUP option by D4 token:

./syscfg –t=D4_token_id

(Example: ./syscfg -t=0x002D to enable NIC1 Option ROM)

•To check token activity status:

./syscfg --istokenactive=D4_token_id

(Example: ./syscfg --istokenactive=0x002D to check the token activity status of NIC1 Option ROM)

•To change the SETUP option through BMC memory directly:

./impitool raw <command> <data>

(Example: ./impitool raw 0xc 1 1 3 10 106 42 120 to set IP address of BMC LAN port as 10.106.42.120)

Table 2-1. The D4 Token Table

Token	Setup Option	Description
		Enable the system’s primary embedded
002D	NIC1 Option ROM	network	interface	controller	(full
		function), including its PXE boot-ROM.
002E	NIC Function Support	Disable	the system’s	onboard network
		interface controller.
		Enable the system BIOS, on the next
005C	TOKEN_RBU_EN	reboot, to search for an operating-
		system-initiated BIOS update image.
		Disable the BIOS update. This value is
005Dh	TOKEN_RBU_DIS	set by the BIOS on each reboot of the
		system.
		Enable the system’s primary embedded
006E	NIC1 Option ROM	network	interface controller, but		does
		not enable the NIC’s associated PXE or
		RPL boot-ROM.
009B	Legacy USB Support	Enable USB emulation

68 Using the System Setup Program