Dell C6145 Installing the Sensor Board for 2.5” Hard Drive System, Installing System Components

Installing the Sensor Board for 2.5” Hard Drive System

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Replace the sensor board into the sensor-board holder. Make sure that the stand-off on the sensor-board holder is inserted into the slot on the sensor board. See Figure 3-42.

2Replace the sensor-board assembly into the hard-drive cage. See Figure 3-41.

3Replace the screw that secures the sensor board to the hard-drive cage. See Figure 3-41.

4Connect the sensor board cable to the sensor board. See Figure 5-13.

5Replace the hard-drive cage into the chassis. See Figure 3-32.

6Replace the screws that secure the hard-drive cage to the chassis. See Figure 3-31.

7Connect all the cables to the backplane. See Figure 5-5for 2.5" hard drives.

You must route these cables properly through the tabs on the chassis to prevent them from being pinched or crimped.

8Connect front panel cables to the fan controller board. See Figure 5-11.You must route these cables properly through the tabs on the chassis to prevent them from being pinched or crimped.

9Close the system. See "Closing the System" on page 118.

10Replace the hard drives. See "Installing a Hard Drive into a Hard-Drive Carrier" on page 83.

11Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.

148 Installing System Components