
Switch and Jumper Settings
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
System Configuration Switch Settings
The function of system configuration switch installed on each system board is shown below:
Figure 5-14. System Configuration Switch
Table
Jumper | Function | Off | On |
SW1 | NVRAM Clear | *Disable | Enable |
SW2 | System Reset | *Disable | Enable |
SW3 | Password Enable | *Disable | Enable |
|
|
|
|
SW4 | BMC NMI Enable | *Disable | Enable |
NOTE: The * in the table of system configuration jumper describes the default status and the default state is not active state.
176 Jumpers and Connectors