Connections
Connecting a Computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS 232 input of the projector.
The projector has a RS232 port that allows it to communicate with a computer.
Applications : remote control and data communications.
a)remote control :
-easy adjustment of projector via IBM PC (or compat- ible) or MAC connection.
-allow storage of multiple projector configurations and set ups.
-wide range of control possibilities.
-address range from 0 to 255.
b)data communications :
-sending data to the projector or copying the data from the projector to a hard memory device.
Set up of the Baud Rate for Communication with a Computer.
See 'Change Baudrate PC' in chapter 'Service mode'.
Connecting a RCVDS 05 to the projector.
-Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS's are linked via the expansion module.
-Serial communication with the projector.
-Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
-The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED on the rear.
For more information about the use of : the RCVDS 05, consult the
owner's manual, order number : R5975765.
Connecting a VS05 to the projector
The VS05 can switch up to 5 Composite Video sources, 3 Super Video sources and 1 RGB analog or component video source to the projector. In addition, the audio signal proper to the source, can be switched to an audio amplifier.
Order number : R9827890
For more information about the use of the VS05, consult the VS05 owner's manual, BARCO order number : R5975245.
|
|
|
|
|
| PROJECTOR MODE : |
|
|
|
|
|
|
|
|
|
|
|
|
|
| GREEN - OPERATION | DIAGNOSTICS |
|
|
|
| |||
RS232 OUT | RS 232IN | COMMUNICATION PORT | RED - STANDBY |
|
| |||||||||
REMOTE |
|
|
|
|
| SDI IN | SDI OUT | XLR | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
R | G | B 56FRQQHFWLRQVG | B | H / C | V | 69,'(29,'(9,'(2,1387 | R | G | B | H / C | V | 9827910 |
|
|
|
|
|
|
| On |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
Connecting an IR Remote Receiver 800 to the projector.
This infrared receiver unit makes it possible to control the projector |
|
from another room. |
|
There is a communication line cable between the IR receiver and the |
|
| |
projector or the RCVDS. The control information from the RCU can | Screen |
now be sent to the IR Remote Receiver 800. | |
The IR Remote Receiver 800 displays the selected source on a 7- |
|
segment display. |
|
Order number : R9827515. |
|
Communication cable
IR Remote Receiver 800
Projector
Projection room | Control room |
| 5976052 BARCOREALITY 9300 070999 | |
|
