Menu Configuration—MAIN MENU
For the operation procedure, see page 7.
Operation guide
Shows the buttons for each operation.
•The menu automatically disappears in about 30 seconds after the previous operation.
•Some items may not appear on the menu depending on the input or the input signal.
•The items controlled by the MAKE system do not appear on the menu.
12
PICTURE FUNCTION
Setting for the picture quality
Item | To do | Setting value |
APERTURE FREQ.*1 | Select the frequency of the luminance signal compensated in | OFF, LOW, HIGH |
| “APERTURE LEVEL.” |
|
APERTURE | Compensate the frequency response of the luminance signal of | 01 – 10 |
LEVEL*1 | the video signal. |
|
CTI | Adjust the clearness of the outlines of the chrominance signal. | OFF, NORMAL, |
|
| HARD |
LTI | Adjust the clearness of the outlines of the luminance signal. | OFF, NORMAL, |
|
| HARD |
I/P MODE | Selects a proper mode corresponding to the input picture. | NORMAL, CINEMA, |
|
| FIELD |
sub menu | Display the sub menu which enables you to adjust the items of “PICTURE FUNCTION” | |
| while viewing the actual picture. |
|
reset | Restore the default settings for all the items in “PICTURE FUNCTION.” | |
*1 Memorized for each input.
BACK LIGHT Setting value:
Adjusts the brightness of the display.
3G SDI LEVEL B Setting value: DS1, DS2
Selects the data stream from two HD SDI signals multiplexed when a 3G SDI level B signal comes in.
SDI DUAL LINK Setting value: OFF, ON
Activates/deactivates the DUAL LINK function of SDI signals.
•“DUAL LINK” is displayed when the setting is set to “ON.” No other status indications of SDI signals are displayed.
•Set this setting to “OFF” when an SDI signal other than DUAL LINK SDI is input.
